Filter
Top Products
13
SPECIFICATIONS
6000 Series Forward Mount
CHASSIS: Sheet metal construction frame.
BODY: Folded sheet metal. Seat lifts up for access to battery and belt service.
SEAT: Designed for operator comfort by use of high density closed cell foam
padded back and arm rests, upholstered with CorduraTM water-
repellent fabric. Seat is adjustable fore and aft.
MOWER DECK: Two decks are available. Both are made of 12 GA fabricated welded
construction with 10 GA reinforcement plate. Three blades
combine for either a 48” or 60” cut width. Cut height approximately 1”
to 5” via 9 position lift handle.
BLADE DRIVE: Electric clutch.
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear BDU-10L Series
70 hydrostatic transmission. The hydrostatic transmissions, in turn,
power a fully enclosed HydroGear gearbox.
ENGINE: 23 HP Kohler Command, 4-cycle, v-configuration, overhead valve, air
cooled, gasoline, horizontal shaft, aluminum head, and crankcase with
cast iron liners, full pressure lubrication/full flow filter, pulse-type fuel
pump, fixed jet carburetor w/smart-choke, electronic ignition, in-line fuel
filter, dual element air cleaner.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on parking brake
and blade drive clutch.
TIRES: Front 4.10 x 3.50-4
Rear 6.00 x 13.00-5
Drive 10.0 x 10.00-20
RECOMMENDED Front 16 lbs.
TIRE PRESSURE: Rear 12 lbs.
CAPACITIES: Fuel - 5 gallons
Hydrostat oil tank - 3 quart with in-line 40 micron filter
Hydrostat oil recommendation, refer to page 29
Engine - 2 quarts SAE 10W30 (with filter)
DIMENSIONS: Width 57-1/2”(48” Deck) 69-1/2” (60” Deck)
Height 45-1/2”
Length 96” (48” Deck), 101” (60” Deck)
Weight 960 lbs. (48” Deck), 1030 lbs. (60” Deck)
Additional information provided in service instructions under the individual component.