Filter
Top Products
13
SPECIFICATIONS
Model ZTR 5020
CHASSIS: 11 GA - rectangular tube
BODY: Two piece-made of rotational molded polyethylene. Front
body contains access panels for battery service & engine
to mower deck belt removal. Rear body tilts up to allow
service on the entire drive system.
SEAT: Designed for operator comfort by use of high-density
closed cell foam padded back rest and arm rests,
upholstered with Cordura
TM
water-repellent fabric. Seat
is adjustable fore and aft.
MOWER DECK: Two decks are available. The 60” is made of stamped
steel. The 50” is made of 11 GA fabricated welded
construction with external reinforcement ribs. Three
blades combine for either a 50” or 60” cut width. Cut
height approximately 1.5” to 4.5” via 7 position lift handle.
BLADE DRIVE: Electric clutch
DRIVE SYSTEM: Each rear wheel is independently driven by a HydroGear
BDU-10L Series 70 hydrostatic transmission. The hydrostatic
transmissions power a fully enclosed HydroGear gearbox.
ENGINE: 20HP Briggs & Stratton ELS, overhead valves, replaceable
oil filter, full pressure lube system, dual element air cleaner,
integral fuel pump.
STARTING SYSTEM: Electric by key switch operation with safety interlocks on
parking brake and blade drive clutch.
TIRES: Front 11 X 4-5 ribbed tread
Rear 20 X 10-8 Multi-Trac
RECOMMENDED Front 16 - 21 lbs.
TIRE PRESSURE: Rear 8 - 14 lbs.
CAPACITIES: Fuel - 4.8 gallons total (dual tanks)
Oil tank - 3 quart with in-line 40 micron filter
Engine - 2 qts. SAE 30 (with filter)
DIMENSIONS: Width 60” (50” Deck), 73” (60” Deck)
Height 45”
Length 72:
Weight 668 lbs, (50” Deck, 685 lbs (60” Deck)
Additional information provided in service instructions under the individual component.
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE