Dixon 115 150227 Lawn Mower User Manual


  Open as PDF
of 15
 
9
ASSEMBLY
4
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY 3
BAGGER SUPPORT ASSEMBLY
Usinghardwareprovidedinkit,attachsupport1.
mount to unit.
Attachhangerbrackettosupportmount.Donot2.
fully tighten nuts at this time.
Secure rear end of support straps to outside of 3.
HangerBracket
hanger assembly. Set reinforcement plates to the
outsideofthetankbracketsandfastenfrontend
ofsupportstraptotankbracketandreinforcment
plate with round head bolt. Secure front end
ofreinforcementplatetotankbracketwithhex
bolt. Fully secure all mounting hardware. See
illustration.
NOTE: Dependingonmodel,rearguardhole
mayneedtobedrilledoutto
5
/16"ifkithardware
istoolarge.
Support Mount
Support Straps
Reinforcement Plate
Hex Bolt Placement
Round Head
Bolt Placement
Cover Assembly
Frame
Bracket
Hanger
For ease of assembly, you may wish assistance from
another person for mounting the cover assembly to
mower.
Position cover assembly on the ground behind 1.
the mower.
Liftandrotatecovertoaligntheframebracket2.
with the hanger and slide the cover down until
secure.
Remove plastic end cap from the center bag
support arm. Fully insert spacer plugs into the
ends of the support tube. It may be necessary
to tap the spacer into place with a hammer or
mallet.Replacetheplasticendcapbackover
the spacer. The additional extension will hold the
hood more securely when latched.
Remove center
end cap
Insert spacer and
replace cap
5
INSTALLING SPACER PLUG
 previous next