Filter
Top Products
8
English
OPERATION
WARNING: To reduce the risk of injury, ALWAYS turn off
tool and disconnect the tool from the power source before
making any adjustments or removing or installing attachments
or accessories. This applies to both the grinder and the dust
extractor vacuum. Such preventative safety measures reduce the
risk of starting the tool accidentally.
WARNING: For your own safety, read the instruction manual for
both the grinding tool and the dust extractor vacuum before using any
accessory. Failure to heed these warnings may result in personal injury
and serious damage to the tool and the accessory. When servicing this
tool, use only identical replacement parts.
WARNING: Hold the side handle and body of the tool firmly to
maintain control of the tool at start up and during use and until the
wheel or accessory stops rotating. Make sure the wheel has come to
a complete stop be fore laying the tool down.
WARNING: Ensure corner door is closed.
1. Ensure all assembly and adjustment instructions have been
completed.
2. Turn the dust extractor vacuum on as instructed in the dust
extractor vacuum instruction manual.
3. Start grinder as instructed in tool instruction manual.
NOTE: Allow the tool to reach full speed before applying to the
work surface.
Tuckpointing and Cutting Application
(Fig. 6)
1. Set the desired depth of cut, see Depth of Cut Adjustment
under Assembly and Adjustments.
2. Allow the tool to reach full speed before touching it to the work
surface.
3. Position yourself so the open underside of the shroud and the
wheel are facing away from you.
4. Place the edge (L) of shroud onto the work surface and begin cut
by plunging into the work surface. NOTE: Keep the edge (L) of the
shroud against the work surface to ensure proper dust collection.
5. With the shroud oriented as shown in Figure 6, move the grinder
right to left along the work surface. For the best results the
grinder should be positioned at a 45° angle to the dust port when
tuckpointing/cutting.
6. Remove the tool from work surface before turning off the tool.
Allow the tool to stop rotating before laying it down.
L
FIG. 6
MAINTENANCE
WARNING: To reduce the risk of injury, ALWAYS turn off
tool and disconnect the tool from the power source before
making any adjustments or removing or installing attachments
or accessories. This applies to both the grinder and the dust
extractor vacuum. Such preventative safety measures reduce the
risk of starting the tool accidentally.