Filter
Top Products
CAUTION: Do not lift the lawnmower
off the ground by holding the height
adjustment finger grip.
• Remove the Grasscatcher frame,
Grassbag and cardboard fillers.
• Remove the mower from the carton and
place all four wheels on the ground or floor.
• Check the carton thoroughly and make
sure there are no loose parts.
To Unfold Handle
Raise the handle section into place and
secure by tightening the two knobs. See
figure below.
WARNING: For your own safety DO NOT
use this mower without either the
Grasscatcher or Mulch Insert in operating
position.
GRASSCATCHER ASSEMBLY
• Slide the grassbag onto the grasscatcher
frame. (See Fig. A)
• The grassbag has attachment clips sewn
around the bag opening.
• Attach the two top clips to the frame,
then attach the side clips, and lastly the
bottom clip. (See Fig. B)
• Refer to “To Install Grasscatcher”
instruction before attaching to mower.
TO INSTALL GRASSCATCHER
• Reach down between the mower handle
and raise the rear door to a vertical
position. (See Fig. A)
• Remove the mulch insert. See page 10
To Remove Mulch Insert.
• Pick up the grasscatcher by the handle
and lower the grasscatcher between the
lawnmower handles. Position the
grass- catcher hanger hooks on the
metal rod under the rear door.
(See Fig. B).
• Release the rear door.
WARNING: Never operate the mower
unless the hanger hooks on the
grasscatcher are seated properly, and the
rear discharge door rests firmly against
the top of the grasscatcher.
6
Handle
Knobs
Clip
A
A
B
598994-00,37051 8/9/05 10:17 AM Page 6