Filter
Top Products
19 — ENG
Water Inlet Screen Cleaning:
All pumps are equipped with some type of water filter
screen. This screen should be checked periodically
and cleaned if necessary. Refer to the illustrations to
the right to determine which filter screen your pump
has. The filter in Figure 20 and 22 can be removed and
cleaned by flushing it with water on both sides. The
filter in Figure 21 can be cleaned using the following
instructions:
1. Insert a 10 mm allen wrench into the bottom of the
filter housing.
2. Turn the housing counterclockwise to remove.
3. Remove the filter screen from the housing and
flush with clean water.
4. Clean any dirt/debris from the filter housing.
5. Place the cleaned filter screen into the housing.
6. Reinstall and tighten securely with a 10 mm allen
wrench.
Figure 20
Figure 21
MAINTENANCE (cont'd)
Figure 22