Filter
Top Products
16- ENG
A17913
1. Drain all water from high pressure hose, coil it, and store it in cradle of the
pressure washer handle.
2. Drain all water from spray gun and spray wand by holding spray gun in a
vertical position with nozzle end pointing down and squeez ing trigger. Store
in gun/hose holder.
3. Store chemical hose, high pressure hose, spray gun, and spray wand so
they are protected from dam age, such as being run over.
It is recommended that you follow these steps to protect the internal seals of the
pressure washer when STORING THE UNIT FOR MORE THAN 30 DAYS AND/OR
WHEN FREEZING TEMPERATURES ARE EXPECTED.
*RV antifreeze needs to be run through the pump as outlined in the steps below.
4. Obtain a funnel, six ounces of *RV antifreeze, and approximately 36 inches
of garden hose with a male hose connector attached to one end.
Risk of property damage. Use only RV antifreeze. Any other
an ti freeze is corrosive and can damage pump.
5. Connect the quick-connect (j) to the garden hose.
6. Connect 36 inch length of hose to water inlet of pump.
7. Add *RV antifreeze to hose as shown.
8. Place the ON-OFF switch in the On position then Off position until an ti-
freeze comes out of high pressure hose con nec tion of pump.
9. Remove garden hose from water inlet of pump.
* Windshield washer fluid may also be used
STORAGE
j