Filter
Top Products
13 - ENG
A17913
STARTING
NOTE: Make sure water supply is turned
on.
1. Disengage the safety catch as shown.
Depress trigger to allow air to escape
and to discharge residual pressure in the
pipes.
2. With the trigger depressed, place the
ON-OFF switch in the On position. When starting motor, always keep the
trigger depressed.
Risk of fluid injection and laceration. Always engage the
trigger lock when gun is not in use. Failure to do so could
cause accidental spraying.
Risk of property damage. If after running unit for a few
minutes it does not maintain steady water pressure, turn
unit off to prevent damage to the unit and see the troubleshooting guide
for instructions.
RECOMMENDED CLEANING
• On vertical surfaces, work from the bottom upwards.
• Let the detergent sit for 1-2 minutes, DO NOT allow detergent to dry.
• To rinse detergent, apply the high pressure jet, keeping the nozzle at least
10 inches from the surface, work from the bottom up.
SHUTTING DOWN YOUR PRESSURE WASHER
1. Place the ON-OFF switch in the OFF position.
2. Turn off water supply.
3. Pull trigger on spray gun to relieve any water pressure in hose or spray gun.
4. Disconnect water supply hose from water inlet.
5. Disconnect high pressure hose from outlet.
6. If cleaning solution application unit was used, rinse cleaning solution
application tank and nozzle thoroughly.