Filter
Top Products
7 — ENG
1. Connect threaded end of multi-reg wand to spray
gun as shown. Tighten securely.
ASSEMBLY
ASSEMBLY
1. Open carton.
2. Remove plastic bag containing handle and engine
manual supplied by engine manufacturer.
3. Remove cardboard from top of unit and inner
cardboard from around unit.
4. Remove plastic bag containing two knobs, nozzle
cleaning kit, instructional video, English Owner's
Manual, and Spanish Owner's Manual from
carton.
5. Remove spray gun, multi-reg wand, and bottle of
engine oil from carton.
6. Using box cutting tool, cut the four corners of the
shipping carton from top to bottom, then lay
panels flat. NOTE: Be careful not to cut into
chemical hose and high pressure hose.
7. Insert handle ends into pressure washer frame as
shown.
8. Install two knobs as shown in and tighten se-
curely.
Knobs
UNPACKING
2. Place assembled spray gun, multi-reg wand, and
chemical hose in gun/hose holder, with multi-reg
wand facing down.
3. Add 30 weight engine oil (supplied) to engine.
Refer to engine manual supplied by engine manu-
facturer for procedure. Do not overfill. Use of a
funnel is recommended.
NOTE
There will be a slight amount of oil in the
engine from factory testing.
NOTE
The engine on this pressure washer is
equipped with a low oil sensor. The amount of
oil in the engine must be correct or the engine
will not start.
NOTE
The DAPC pump on your pressure washer is
filled with oil at the factory. There is no need to
add oil at this time, see the Maintenance
section of this manual to perform maintenance
on this pump.
add oil
9. Grasp handle and roll unit off of carton.
10. Remove high pressure hose from carton and store
in gun/hose holder as shown in Pressure Washer
Basics section in this manual.