Filter
Top Products
13 — ENG
OPERATION
SHUTTING DOWN YOUR PRESSURE
WASHER
1. If you have siphoned chemicals or cleaners, you
must siphon clean water through chemical hose to
flush chemical injector.
2. Continue to siphon clean water through hose and
pump for at least one minute before turning off
engine.
NOTE
Failure to siphon clean water through chemical
hose and pump after siphoning chemicals or
cleaners can cause damage to pump.
WHEN USING THE HIGH PRESSURE
SETTING, DO NOT ALLOW THE HIGH
PRESSURE SPRAY TO COME IN CONTACT
WITH UNPROTECTED SKIN, EYES, OR
WITH ANY PETS OR ANIMALS. SERIOUS
INJURY CAN OCCUR.
DO NOT stop spraying water for more than
two minutes at a time. Pump operates in
bypass mode when spray gun trigger is not
pressed. If pump is left in bypass mode for
more than two minutes internal components
of the pump can be damaged.
DO NOT let hoses come in contact with
very hot engine muffler during or immedi-
ately after use of your pressure washer.
Damage to hoses from contact with hot
engine surfaces will NOT be covered by
warranty.
6. Depress trigger on gun to start water flow. Release
trigger to stop water flow.
STAND ON A STABLE SURFACE AND GRIP
GUN/WAND FIRMLY WITH BOTH HANDS.
EXPECT THE GUN TO KICK WHEN
TRIGGERED.
7. Adjust nozzle spray for the task being performed.
See How To Use Wand instructions in the Opera-
tion section.
3. Move throttle control to STOP position to stop
engine.
Throttle Control
FAST
SLOW
STOP
4. Turn off water supply.
Never turn water supply off while pressure
washer engine is running or damage to
pump will result.
DO NOT let hoses come in contact with
very hot engine muffler during or immedi-
ately after use of your pressure washer.
Damage to hoses from contact with hot
engine surfaces will NOT be covered by
warranty.
5. Pull trigger on spray gun to relieve any water
pressure in hose or spray gun.
6. Disconnect water supply hose from pump.
7. Coil high pressure hose and store in gun/hose
holder.
8. Place spray gun in gun/hose holder.
9. Place chemical hose in gun/hose holder.