Filter
Top Products
www.desatech.com
115423-01A 9
7. Tubular heating element must be flush against
bracket (see Figure 14). This centers the ele
-
ment to the center hole in metal pan.
8. Fan must be located with set screw at back of
and on flat of shaft (see Figure 15).
9. Heater is equipped with heat reflective tape.
If loose or damaged, replace tape as shown in
Figures 16 and 17. Tape edge should touch top
of louver openings.
REASSEMBLY POINTS
Continued
Figure 14 - Heating Element and Bracket
Figure 15 - Fan and Motor
Figure 16 - Reflective Tape and Louvers
Figure 17 - Reflective Tape on All Louvers
Motor
Shaft
Back of, and
Flat of Motor
Shaft
Fan Set
Screw