Filter
Top Products
9- ENG
D29382
HOW TO USE THE CLEANING SOLUTION APPLICATION UNIT
NOTE: Use only soaps and cleaning solutions designed for pressure washer
use. Do not use bleach.
1. Place the ON-OFF switch in the OFF position.
2. Turn off the water supply.
3. Attach cleaning solution application unit to wand as shown and tighten
securely. Grasp end of nozzle and turn until cleaning solution application unit
is oriented correctly.
fan spray
jet stream
HOW TO USE
IMPORTANT: Read and understand how to use the pressure washer before
operating.
HOW TO USE SPRAY WAND
The nozzle at the end of the wand can be rotated to change from narrow jet
stream to fan jet, as shown.
Total Stop System: This unit is equipped with a total stop system. When the
trigger is released the motor is shut off automatically. When the trigger is pressed
again the motor will automatically start. The time between release and engage-
ment must not be less than 4-5 seconds. DO NOT leave the unit in automatic
stop mode for more than 15 minutes.
psi: Pounds per Square Inch. The unit of measure for water pressure. Also used
for air pressure, hydraulic pressure, etc.
GPM: Gallons Per Minute. The unit of measure for the flow rate of water through
the pressure washer.
CU: Cleaning Units. GPM multiplied by psi.
Water Supply: All pressure washers must have a source of water. The minimum
requirements for a water supply are 20 psi and 5 gallons per minute.