Filter
Top Products
3
Installing MD Storage Manager
The PowerVault MD Series resource media contains software and drivers for both Linux and Microsoft
Windows operating systems.
The root of the media contains a readme.txt file describing changes to the software, updates, fixes,
patches, and other important data applicable to both Linux and Windows operating systems. The
readme.txt file also specifies requirements for accessing documentation, information regarding versions
of the software on the media, and system requirements for running the software.
CAUTION: Do not install MD Storage Manager exclusively on a virtual disk that is being actively
managed by MD Storage Manager. Instead, install at least one instance of MD Storage Manager
on a local disk that is running SMagent and SMmonitor. Installing management software only on
a virtual disk may prevent access to recovery information in the event of multiple physical disk or
enclosure failures.
For more information on supported hardware and software for Dell PowerVault systems, see the Support
Matrix at dell.com/powervaultmanuals.
NOTE: As a first step towards managing the array, always use MD Storage Resource DVD media to
update and install MD Storage Manager. For the latest updates and Support Matrix, see dell.com/
powervaultmanuals.
The PowerVault MD3460 Series storage firmware installer provides features that include the core
software and providers. The core software feature includes the host-based storage agent, multipath
driver, and MD Storage Manager application used to configure, manage and monitor the storage array
solution. The providers feature include providers for the Microsoft Virtual Disk Service (VDS) and
Microsoft Volume Shadow-Copy Service (VSS) framework.
NOTE: For more information about the Microsoft VDS and Microsoft VSS providers, see the
Administrator's Guide at dell.com/powervaultmanuals.
NOTE: To install the software on a Windows or Linux system, you must have administrative or root
privileges.
NOTE: If Dynamic Host Configuration Protocol (DHCP) is not used, initial configuration of the
management station must be performed on the same physical subnet as the storage array.
Additionally, during initial configuration, at least one network adapter must be configured on the
same IP subnet as the storage array’s default management port (Controller 0 MGMT (port 0) :
192.168.128.101 or Controller 1 MGMT (port 0): 192.168.128.102). After the initial configuration, the
management ports are configured using MD Storage Manager and the management station’s IP
address can be changed back to the previous settings.
NOTE: Only two management ports (Port 0) per array are supported. Second port on each
controller is reserved.
19