Cub Cadet LTX1046 Lawn Mower User Manual


  Open as PDF
of 36
 
To properly sharpen the cutting blades, remove equal 4.
amounts of metal from both ends of the blades along the

angle. Always grind each cutting blade edge equally to

CAUTION: If the cutting edge of the blade has
previously been sharpened, or if any metal
separation is present, replace the blades with new
ones.
WARNING! A poorly balanced blade will cause
excessive vibration, may damage to the tractor
and/or result in personal injury.
5.
metal from the heavy side until it balances evenly.
NOTE: When replacing the blade, be sure to install the blade with

stamped in it) facing the ground when the mower is in the
operating position.
CAUTION: Use a torque wrench to tighten the


Battery
CALIFORNIA PROPOSITION 65 WARNING:

contain lead and lead compounds, chemicals known

reproductive harm. Wash hands after handling.
CAUTION: If removing the battery, disconnect the



(Red) wire its terminal first, followed by the

Jump Starting
WARNING! Never jump start a damaged or frozen

ignitions are off. Do not allow cable clamps to touch.
Connect positive ( +) cable to positive post (+) of your

Connect the other end of the cable to the positive (2. +) post
of the jumper battery.
Connect the second cable negative ( –) to the other post of
the jumper battery.
Make the final connection on the engine block of the 4.
tractor, away from the battery. Attach to a unpainted part
to assure a good connection.
CAUTION: If the jumper battery is installed on a

engine when jump starting your tractor.
5.
this manual).
6.
cables, in reverse order of connection.
Charging
WARNING! 
while charging. Charge the battery in a well
ventilated area and keep away from an open flame
or pilot light as on a water heater, space heater,
furnace, clothes dryer or other gas appliances.
CAUTION: 



Always follow its instructions and heed its warnings.
If your tractor has not been put into use for an extended period
of time, charge the battery as follows:

If your battery charger is automatic, charge the battery 2.
until the charger indicates that charging is complete. If the
charger is not automatic, charge for no fewer than eight
hours.
Figure 7-6
26 se c t i O n 7— se r v i c e
 previous next