Filter
Top Products
2. Disengage the PTO (Blade Engage), set the
parking brake and stop the engine.
3. Thread the hose coupler (packaged with your
tractor's Operator's Manual) onto the end of your
garden hose.
4. Attach the hose coupler to the water port on your
decks surface. See Figure 15.
Hose Coupler
Water Port
Figure 15
5. Turn the water on.
6. While sitting in the operator's position on the
tractor, start the engine and place the throttle lever
in the FAST (rabbit) position.
7. Move the tractor's PTO (Blade Engage) into the ON
position.
8. Remain in the operator's position with the cutting
deck engaged for a minimum of two minutes,
allowing the underside of the cutting deck to
thoroughly rinse.
9. Move the tractor's PTO (Blade Engage) into the
OFF position.
10. Turn the ignition key to the STOP position to turn
the tractor's engine off.
11. Turn the water off and detach the hose coupler
from the water port on your deck's surface.
12. Repeat step 4- step 11 on the opposite side of the
cutting deck (Models LT 1045, LT 1046 and
LT 1050).
Lubrication
WARNING: Before lubricating, repairing, or
inspecting, always disengage PTO, set
parking brake, stop engine and remove key to
prevent unintended starting.
Engine
Refer to Engineon page 19 for instruction regarding all
engine-related lubrication.
FrontWheels
Each of the front wheel axles and rims is equipped with
a grease fitting. See Figure 16. Lubricate with a No. 2
multi-purpose grease applied with a grease gun after
every 25 hours of tractor operation.
\
RimGreaseFitting
\
Figure 16
PivotPoints& Linkage
Lubricate all the pivot points on the drive system,
parking brake and lift linkage at least once a season
with light oil.
DeckWheels
Each of the tractor deck's front gauge wheels is
equipped with a grease fitting. Lubricate with a No. 2
multi-purpose grease applied with a grease gun after
every 25 hours of tractor operation
DeckSpindle
Grease fittings can be found on the front of each deck
spindle. Lubricate with 251H EP grease or an
equivalent No. 2 multi-purpose lithium grease. Using a
grease gun, apply two strokes (minimum) or sufficient
grease to the spindle shaft.
DeckIdler (ModelLTlO5Oonly)
A grease fitting can be found on the pivoting idler
bracket on the rear of 50-inch decks. Lubricate with a
No. 2 multi-purpose grease applied with a grease gun
after every 25 hours of tractor operation.
23