Filter
Top Products
8
NOTE: One gallon (3.8 liters) of unleaded gasoline
mixed with one 3.2 oz. (95 ml) bottle of
2-cycle oil makes a 40:1 fuel/oil ratio.
Gasoline is extremely flammable. Ignited Vapors
may explode. Always stop the engine and allow it
to cool before filling the fuel tank. Do not smoke
while filling the tank. Keep sparks and open flames
at a distance from the area.
Remove fuel cap slowly to avoid injury from fuel
spray. Never operate the unit without the fuel cap
securely in place.
Add fuel in a clean, well ventilated area outdoors.
Wipe up any spilled fuel immediately. Avoid
creating a source of ignition for spilt fuel. Do not
start the engine until fuel vapors dissipate.
NOTE: Dispose of the old fuel/oil mix in accordance
to Federal, State and Local regulations.
Oil and Fuel Mixing Instructions
Old and/or improperly mixed fuel are the main reasons
for the unit not running properly. Be sure to use fresh,
clean unleaded fuel. Follow the instructions carefully for
the proper fuel/oil mixture.
Definition of Blended Fuels
Today's fuels are often a blend of gasoline and
oxygenates such as ethanol, methanol, or MTBE (ether).
Alcohol-blended fuel absorbs water. As little as 1%
water in the fuel can make fuel and oil separate. It forms
acids when stored. When using alcohol-blended fuel,
use fresh fuel (less than 60 days old).
Using Blended Fuels
If you choose to use a blended fuel, or its use is
unavoidable, follow recommended precautions:
• Always use the fresh fuel mix explained in your
operator's manual
• Always agitate the fuel mix before fueling the unit
• Drain the tank and run the engine dry before storing
the unit
Using Fuel Additives
The bottle of 2-cycle oil that came with your unit
contains a fuel additive which will help inhibit corrosion
and minimize the formation of gum deposits. It is
recommended that you use our 2-cycle oil with this unit.
If unavailable, use a good 2-cycle oil designed for
air-cooled engines along with a fuel additive, such as
STA-BIL
®
Gas Stabilizer or an equivalent. Add 0.8 oz.
(23 ml.) of fuel additive per gallon of fuel according to the
instructions on the container. NEVER add fuel additives
directly to the unit's fuel tank.
For proper engine operation and maximum
reliability, pay strict attention to the oil and fuel
mixing instructions on the 2-cycle oil container.
Using improperly mixed fuel can severely damage
the engine.
Thoroughly mix the proper ratio of 2-cycle engine oil
with unleaded gasoline in a separate fuel can. Use a 40:1
fuel/oil ratio. Do not mix them directly in the engine fuel
tank. See the table below for specific gas and oil mixing
ratios.
Oil and Fuel
Section 4
UNLEADED GAS 2 CYCLE OIL
1 GALLON US
(3.8 LITERS)
3.2 FL. OZ.
(95 ml)
1 LITER 25 ml
+
MIXING RATIO - 40:1