Filter
Top Products
12
Operation (continued)
Fig. 5-6
DECORATIVE TRIMMING
Decorative trimming is accomplished by removing all
vegetation around trees, posts, fences, etc.
Rotate the whole unit so that the cutting attachment is
at a 30° angle to the ground (Fig. 5-6).
Section 6
Maintenance
NOTE: Some maintenance procedures may require
special tools or skills. If you are unsure about these
procedures take your unit to an authorized service
dealer.
MAINTENANCE SCHEDULE
These required maintenance procedures should be
performed at the frequency stated in the table. They
should also be included as part of any seasonal tune-up.
To prevent serious injury, never do maintenance
or repairs with unit running. Always do
maintenance and repairs on a cool unit.
Disconnect spark plug wire to ensure the unit will
not start.
MAINTENANCE NEEDED
Fill fuel tank with correct oil and fuel mixture.
Clean and re-oil air filter.
Check spark arrestor and clean
Check spark plug condition and gap
WHEN
Before Starting Engine
Every 10 Hours
Every 25 Hours
GO TO:
Page 9
Page 15
Page 15
Page 17
Bump Knob
Bolt
Fig. 6-1
LINE INSTALLATION
This section covers both Membrane line and standard
single line installation.
Always use manufacturer’s 0.095 inch (2.41 mm)
replacement line. Using line other than specified may
make the engine overheat or fail.
Never use metal-reinforced line, wire, chain, or
rope, etc. These can break off and become
dangerous projectiles.