Filter
Top Products
18
Front Wheel Drive Lever
The front wheel drive lever is located in the
floorboard, below and to the left of the seat.
Use the front wheel mechanism only when additional
traction is needed to drive the tractor. For example:
when operating ground engaging equipment such as
a front end loader; when climbing slopes; or when
operating in wet, sandy or loose soil conditions.
• To engage the front wheel drive mechanism,
depress the clutch pedal and push the front
wheel drive lever downward. See Figure 15.
• To disengage the front wheel drive, depress the
clutch pedal and pull the lever upward.
Figure 15
Differential Lock Pedal
Located at the rear of the right floor board, the differ-
ential lock is used to gain additional traction when
operating the tractor on wet or loose soil. When the
pedal is depressed the rear wheels of the tractor are
prevented from rotating independently of one another.
See Figure 16.
Figure 16
WARNING: When operating with the
differential lock engaged, the tractor will
be difficult to steer. To prevent loss of
control of the tractor, do not drive the
tractor on roadways or at speeds above 5
MPH with the differential lock engaged.
• To engage the differential lock, lightly step on the
differential lock pedal with your heel.
• To disengage, simple release the pedal.
Hydraulic Control Levers
The hydraulic control levers, consisting of the position
control and draft control levers, are located on the
right fender. See Figure 17.
Figure 17
Use these control levers to control the working depth
and pull of implements attached to the three point
hitch as follows:
• Using Position Control — This will control the
working depth of 3-point implements regardless
of the amount of pull required. Push the draft
control lever forward to the lowest position and
set the implement working depth by moving the
position control lever to the desired position.
• Using Draft Control — This will control the pull of
the 3-point implement. As the pull on the 3-point
hitch changes due to various soil conditions, the
draft control system automatically responds to
these changes by either raising or lowering the
implement slightly to maintain a constant pull.
Push the position control lever forward to the
lowest position and set the implement pull by
moving the draft control lever to the desired
setting.
FRONT WHEEL
DRIVE LEVER
Engaged
Disengaged
Engage
DIFFERENTIAL
LOCK PEDAL
POSITION
CONTROL
LEVER
DRAFT
CONTROL
LEVER
Raise
Raise
Lower
Lower