Filter
Top Products
6
The Optional Remote 3rd Hole Slide - Part No. 02004521
Mounting Instructions
1. Mount the dual lever bracket (Ref. 1) to the right
handle using one machine screw (Ref. 2), one flat
washer (Ref. 3) and one hex nut (Ref. 4) as shown
below.
2. Mount the dual remote lever (Ref. 5) to the dual
lever bracket (Ref. 1) using one machine screw
(Ref. 6), two nylon flat washers (Ref. 7) and one
hex nut (Ref. 4) as shown below.
3. Slide the control cable (Ref. 8) through the hole in
the dual remote lever and the cable housing into
the fork of the dual lever bracket and pinch the
forks around the cable groove.
4. With the dual remote lever pushed all the way
forward attach the other end of the control cable to
the hole in the 3rd hole slide. Push the slide fully
closed and mount the cable housing to the shut off
plate using the cable clamp (Ref. 9), two machine
screws (Ref. 10), two lock washers (Ref. 11) and
two hex nuts (Ref. 12) as shown below.
5. Work the dual remote lever back and forth to be
sure that you are getting the full open and full
closed positions of the 3rd hole slide. If not, loosen
the cable clamp and adjust the cable.
Ref.
No.
Part No. Description Qty.
1 00030418 Bracket, Dual Lever 1
2 00060047 Machine Screw 1
3 00060033 Flat Washer 1/4 1
4 00060036 Hex Nut, 1/4-20 Nylock 2
5 00030416 Lever, Dual Remote 1
6 00060057 Machine Screw 1
7 00018628 Flat Washer, 1/4 Nylon 2
8 00030450 Control Cable 1
9 00020511 Cable Clamp 1
10 00031686 Machine Screw 2
11 00060083 Lock Washer #8 2
12 00060056 Hex Nut, #8-32 2
13 00060054 Shut off Plate Assembly 1
00020491 Remote Shut off Plate 1
00020492 Slide Lever 1
Parts List
Impeller Shaft Support
Bottom of Hopper
13