Filter
Top Products
2
• Remove the dash panel insert by removing the two
screws and lifting the insert out (See Figure 2).
• Locate the unused dash harness connector (with
green(2), green w/white, red w/black, yellow w/
black, and violet wires) inside the dash panel. Lift
the connector up through the hole in the dash panel
from which the plug was just removed.
Figure 2
• Align the cruise switch (Ref.6) and the dash har-
ness connector so that the locator tabs on each side
of the connector will slide up on the flat area of the
switch, then plug the switch into the connector. See
Figure 3.
Figure 3
• With the light area of the switch positioned toward
the top, push the cruise switch fully into the hole in
the dash panel.
• Reinstall the dash panel insert and secure with the
two screws.
• Remove the four hex tapp screws and two truss
head screws securing the fender cover; then re-
move the cover from the tractor. Refer to Figure 4.
Figure 4
• From beneath the right running board, locate the
hex lock nut on the end of the pedal shaft. Using a
3/4" socket and long socket extension, loosen the
lock nut so that it is unthreaded beyond the end of
the pedal shaft threads. See Figure 5.
Figure 5
IMPORTANT: Use care to avoid damaging the hydrau-
lic outlet tubes when completing the following step.
• Using a mallet and a 3/4" or larger bar placed
against the hex lock nut, carefully drive the pedal
shaft toward the left side of the tractor.
NOTE: The control linkage of the tractor will limit the dis-
tance the pedal shaft can be moved. Do not force the
pedal shaft; move the shaft only as far as necessary to
install the lock washer and nut on the frame side of the
pedal shaft plate. Refer to Figure 6.
• Slide the compression spring (Ref. 2), large end
first, onto the special screw. Refer to Figure 6.
• Insert the double ‘D’ end of the special screw (Ref.
1) into the double ‘D’ hole of the pedal shaft plate.
Refer to Figure 6.
Dash Panel
Insert
Screws
Dash Harness
Connector
Cruise Switch
Connector
Locator Tab
Flat Area
Remove Screws
Fender
Cover
Bearing Plate
Pedal Link
Pedal Shaft
Hex Lock Nut