Cub Cadet 421R Snow Blower User Manual


 
11
Lubrication
Lubricate pivot points on the control handle and the
extension spring at the end of the clutch cable with
a light oil once every season and before storage of
the snow thrower at the end of the season.
Engine
Refer to the separate engine operators manual
packed with your snow thrower for all engine
maintenance procedures.
Check engine and snow thrower frequently for
loose hardware, and tighten as needed.
SECTION 7: OFF-SEASON STORAGE
WARNING: Never store engine with fuel in
tank indoors or in enclosed, poorly ventilated
areas where fuel fumes may reach an open
flame, spark or pilot light as on a furnace,
water heater, clothes dryer, or other gas
appliance.
Clean snow thrower thoroughly.
Lubricate as instructed above with a light oil.
Follow Storage instructions in the Engine Manual.
Store in a clean, dry area. Block the snow thrower
up so it is not resting on the rubber auger blades.
NOTE: When storing any type of power equipment in
an poorly ventilated or metal storage shed, care should
be taken to rustproof the equipment, especially springs,
cables and all moving parts.