Filter
Top Products
17
• Slide the boot cover all the way up (toward the drive
handles) to access the drive handle bolts.
• Remove drive handle bolts, drive handles, and
rubber boot.
• Remove the four bolts securing the retaining plate
to the control tower cover.
• Pull up on the control tower cover and slide up and
over the control tower.
• Locate the rear of the light fixture where the wire
attaches. See Figure 17.
• Remove the wire from the light bulb assembly and
squeeze the tab on the connector that attaches the
wire to the light bulb assembly.
• Pull the wire from the light bulb assembly and turn
the light bulb assembly counterclockwise to release
it from the light fixture.
Figure 17
• Carefully pull the light bulb out of the light fixture
and insert the replacement light bulb into the light
fixture.
• Turn the light bulb assembly clockwise until it locks
in place and carefully insert the connector into the
light bulb assembly.
• Replace the control tower cover and drive handle
assemblies.
Changing The Fuse
• The fuse can be located on a wiring harness in a
protective cover between the engine and the
battery.
• Remove the old fuse and replace with same rated
fuse.
Battery
The battery is sealed and is maintenance free. Acid
levels can not be checked.
• Always keep the battery, cables, and terminals
clean and free of corrosive build-up.
• After cleaning the battery and terminals, apply a
light coat of petroleum jelly or grease to the
terminals and over the positive terminal boot.
• Always keep the boot positioned over the positive
terminal to prevent shorting.
IMPORTANT:
If removing the battery for any reason,
disconnect the NEGATIVE (Black) wire from it’s
terminal first, follow by the POSITIVE (Red) wire. When
reinstalling the battery, always connect the POSITIVE
(Red) wire to it’s terminal first and the NEGATIVE
(Black) wire second. Be certain that the wires are
connected to the correct terminals.
Charging
If the unit has not been in use for an extended period of
time, charge the battery with an automotive-type 12-volt
charger for a minimum of one hour at six amps. Never
store battery without a full charge.
Tires
The two front wheels are caster wheels that swivel to
accommodate the direction of the Z-Series. The two
rear wheels are used to propel the Z-Series in the
direction of input from the drive handles. Inflation
pressure of the tires is important for stability while the Z-
Series is in operation. See tire side wall for proper
inflation pressure.
WARNING: Periodically inspect the blade
adapter for cracks, especially if you strike
a foreign object. Replace when necessary.
Removing The Drive Belt
Visually inspect the drive belt for wear and cracking. If
the drive belt shows signs of glazing, fraying, cracking
or excess wear it needs to be replaced. Follow these
steps to replace the drive belt.
• Set parking brake and remove the mower deck belt
from the engine pulley. See Removing the Mower in
MOWER DECK section.
• Locate the drive belt and roll drive belt down off the
left drive pulley.
• Then roll the drive belt down off the right drive
pulley and remove the drive belt from the engine
pulley.
Headlight
Mounting
Bracket
Light
Bulb
Connector