Cub Cadet 31AH4Q3G100 Snow Blower User Manual


 
7
Figure 7
Retighten the hex nuts loosened earlier.
Repeat this adjustment on the skid shoe found on
the opposite side of the snow thrower.
Tire Pressure
The tires are overinflated for shipping purposes.
Check tire pressure, by referring to tire sidewalls for
recommended tire pressure.
NOTE: If the tire pressure is not equal in all tires, the
unit may pull to one side or the other.
WARNING: Maximum tire pressure under
any circumstance is 30 psi. Equal tire
pressure should be maintained at all
times. Excessive pressure (over 30 psi)
when seating beads may cause tire/rim
assembly to burst with force sufficient to
cause serious injury.
SECTION 3: KNOW YOUR SNOW THROWER
Figure 8
WARNING: Read, understand, and follow
all instructions and warnings on the
machine and in this manual before
operating.
Traction Control / Auger Control Lock
The traction control is located on the right handle.
Squeeze the traction control to engage the wheel drive.
Release to stop. See Figure 8.
This same lever also locks the auger control to avoid
interruption of the snow throwing process. If the auger
control is engaged along with the traction control, the
operator can release the auger control (on the left
handle) and the augers will remain engaged. Release
the traction control to stop both the augers and wheel
drive (auger control must also be released).
IMPORTANT:
Always release tractional control before
changing speeds.
Skid
Hex Nuts
Shoes
Traction Control /
Auger Control Lock
Shift Lever
Chute Tilt
Control
Headlight
Discharge
Chute
Auger Drive Control
Trigger Lever
Electric Chute
Rotation Switch
Heated Handles
Switch
Skid Shoe
Auger
Switch
Box
Electric
Starter
Button
Recoil
Starter
Handle
Primer
Choke
Safety
Ignition Key
Throttle
Control
Closed
Open