Cub Cadet 190- 670-100, 190-678-100 Lawn Mower User Manual


 
7
SECTION 3: ASSEMBLY & OPERATION
NOTE: References to LEFT, RIGHT , FRONT and
REAR of the tractor are from the operator’s position.
Before assembly, place the tractor on a firm and
level surface, disengage the PTO, stop the tractor
engine and set the parking brake.
Mounting Bracket Assembly
NOTE: For convenience, pivot the seat forward and
leave it in that position until the grass collector is fully
mounted and assembled.
Remove the hairpin clip and clevis pin from the rear
of the mounting bracket assembly.
Position the hooked ends of the bracket assembly
to the outside of the hitch plate and over the
shoulder bolts. See Figure 2.
Figure 2
Reinsert the clevis pin through the aligned holes in
both the bracket assembly and the hitch plate and
secure with the hairpin clip. See Figure 3.
Figure 3
IMPORTANT:
There are two holes in the clevis pin. Be
sure to insert the hairpin clip in the upper hole to
properly secure the bracket assembly to the hitch plate.
Attaching the Grasscatcher Cover and Bags
Slide the support tube down through the holes in
the left side of the mounting bracket assembly. Use
the inside hole on the bracket assembly regardless
of what size deck your tractor is equipped with. See
Figure 4.
Figure 4
Place the grasscatcher cover assembly in position
so that the support tube rests on the right side of
the mounting bracket assembly. Allow the plastic
cover to rest in the open position . See Figure 4.
Figure 5
Mounting
Bracket
Shoulder
Bolt
Hitch Plate
Clevis
Pin
Hairpin Clip
Align these
holes
Support
Holes
Mounting
Tube
Bracket Assembly
Clevis Pin
Bell Washer
Click Pin
Slots
Slots