Filter
Top Products
NOTE: THIS ELECTRIC STARTER IS THER-
MALLV PROTECTEO. IF OVERHEATED IT
WILL STOP AUTOMATICALL V, ANO CAN BE
REST ARTEO ONL V WHEN IT HAS COOLEO
TO A SAFE TEMPERATURE. (A WAIT OF
ABOUT 5 TO 10 MINUTES IS REQUIREO:j
C. When engine starts, release STARTER BUT-
TON and move CHOKE gradually to "Off".
D. If engine falters, move CHOKE immediately to
"Full" and then gradually to "Off".
E. Disconnect POWER CORO trom receptacle,
first, and then trom SWITCHBOX.
7. As engine warms up and begins to operate evenly,
rotate choke knob slowly to OFF position. It engine
talters, return to 1/2 choke until it runs smoothly,
then move to OFF choke position. NOTE: Allow the
engine to warm up tor a tew minutes as the engine
will not develop tull power until it reaches operat-
ing temperature.
8. Run engine at or near top speed.
9. To stop engine, move throttle control lever to stop
position and remove key. Do not turn key.
It, after following the preceding instructions, your en-
gine tails to start, have it checked by your nearby Autho-
rized Sears Service Outlet.
Warm Engine Start (Electric Starter)
(Engine stili warm from recent running). Proceed with
the following instructions.
NOTE: Warm engine may start without choking.
NOTE: "WARNING" PERTAINING TO SAFE USE
OF 3-WIRE GROUNDED ELECTRICAL SYSTEM, ON
PAGE 8. ELECTRIC STARTER - 120 VOLT "AC"
ALSO APPLIES TO THESE INSTRUCTIONS. REVIEW
THIS "WARNING" BEFORE PROCEEDING.
NOTE: DO NOT USE PRE-STARTING PRIMER
WHEN USING 120 VOLT ELECTRIC STARTER.
1. Be sure auger drive clutch lever and traction drive
clutch lever are in the disengaged position,
"RELEASED" .
2. Move Throttle Control (UP) to "Fast" position. In-
sert key into ignition slot. Be sure it snaps into piace.
(Figure 11) Do not turn key.
3. Rotate CHOKE knob to "OFF" (Figure 11).
4. Connect POWER CORO to SWITCHBOX. (Figure
11A)
5. Plug other end of POWER CORO into a three hole,
GROUNDED 120V, AC receptacle. (See "warning"
at beginning of these instructions).
6. START ENGINE:
A.
Push STARTER BUTTON (Figure 11A) to en-
gage starter rnotor and crank engine.
B. Move CHOKE on engine to "Full" while crank-
ing engine.
NOTE: THIS ELECTRIC STARTER IS THER-
MALL V PROTECTEO. IF OVERHEATEO IT
WILL STOP AUTOMA TICALL Y, ANO CAN BE
REST ARTEO ONL V WHEN IT HAS COOLEO
TO A SAFE TEMPERATURE. (A WAIT OF
ABOUT 5 TO 10 MINUTES IS REQUIREO.)
C. When engine starts, release STARTER BUT-
TON and move CHOKE gradually to "Off".
D. If engine falters, move CHOKE immediately to
"Full" and then gradually to
"Oft".
E. Disconnect POWER CORO trom receptacle,
first, and then from SWITCHBOX.
7. Run engine at or near top speed.
8. To stop engine, move throttle control lever to stop
position and remove key. Do not turn key.
If, after tollowing the preceding instructions, your en-
gine tails to start, have it checked by your nearby Autho-
rized Sears Service Outlet.
DO NOT LOSE IGNITION KEY. KEEP IT IN A
SAFE PLACE. ENGINE WILL NOT START
WITHOUT IGNITION KEY.
9