Filter
Top Products
2.
With engine not running wipe ali snow and
moisture fram carburetor cover (Figure 10) in area
of contrai levers. Also move controllevers backward
and forward several times.
IMPORTANT: After each use of the snowblower, stop
the engine, remove the ignition key, remove ali accu-
mulated snow
tram
the snowblower and wipe clean.
Store the snowblower in a protected area.
Never cover snowblower while engine and exhaust
area are stili warm.
DO NOT LOSE IGNITION KEY. KEEP IT IN A
SAFE PLACE. ENGINE WILL NOT START
WITHOUT IGNITION KEY.
USE OF ELECTRIC STARTER
On models so equipped
A
WARNING: THIS STARTER IS EQUIPPEO
.. WITH A THREE-WIRE POWER CORO ANO
PLUG ANO IS DESIGNEO TO OPERATE ON 120
VOL T AC HOUSEHOLO CURRENT. IT MUST BE
PROPERL Y GROUNOEO AT ALL TIMES TO AVOlO
THE POSSIBILlTY OF ELECTRIC SHOCK WHICH
MAY BE INJURIOUS TO THE OPERATOR. FOLLOW
ALL INSTRUCTIONS CARE FULL Y AS SET FORTH
BELOW. OETERMINE THAT YOUR HOUSE WIRING
IS A THREE·WIRE GROUNOEO SYSTEM. ASK A
LlCENSEO ElECTRICIAN IF YOU ARE NOl SURE.
IF YOUR HOUSE WIRING SYSTEM IS NOT A THREE-
WIRIi GROUNOED SYSTEM, DO NOT USE THIS
ElECTRIC STARTER UNOER ANY CONOITION. IF
YOUR SYSTEM IS GROUNOED ANO A THREE-HOlE
RECEPT AClE IS NOT AVAILABLE AT THE POINT
YOUR STARlER WllL NORMALL Y BE USEO, ONE
SHOULO BE INST AllEO BY A LICENSEO ElEC-
TRICIAN.
A
WARNING: WHEN CONNECTING 120 VOlT
.. "POWER CORO", ALWAYS CONNECT CORO
TO "SWITCH BOX" ON ENGINE FIRSl, ANO THEN
PlUG THE OTHER END INTO THREE-HOLE
GROUNDEO RECEPT ACLE.
A
WARNING: WHEN OISCONNECTING
.. "POWER CORO", AlWAYS UNPLUG lHE
END IN THE THREE-HOLE GROUNOED RECEPT A-
CLE FIRST.
çold Engine Start (Electric Starter)
(See figures 11 and 11A on page 8)
(Engine has not been run recently.)
NOTE: DO NOT USE PRE-SlARTING PRIMER
WHEN USING 120 VOL l ELECTRIC STARTER.
1. Be sure auger drive clutch lever and traction drive
clutch lever are in the disengaged position,
" RELEASEO".
2. Move Throttle Control (UP) to "Fast" position. Insert
key into ignition slot. Be sure it snaps into piace.
(Figure 11). Do not turn
key.
3.
Rotate CHOKE knob to "OFF" (Figure 11).
4.
Connect POWER CORO to SWITCHBOX. (Figure
11A)
OIL FIL CAP/DIPSTICK
.........5TARTER
HANDLE
IGNITION KEV
THAOTTLE CONTROL
OIL DRAIN PLUG LEVER
FIGURE 11
ELECTRIC 5T ARTER
FIGURE 11A
5. Plug other end of POWER CORO into a three hole,
GROUNDED 120V, AC receptacte. (See "warning"
at beginning of these instructions).
6. START ENGINE:
A. Push STARTER BUTTON (Figure 11A) to
engage starter motor and crank engine.
B. Move CHOKE on engine to "Full" while cran-
king engine.
8