Filter
Top Products
CARTONCONTENTS
Checkcartoncontentsagainstthefol-
lowinglist.
Model0944.511591
• Brushcutterattachment
• Handlebar
• Handlebarmountingbracketfor1"
(2.5cm)shaft
• Handlebarmountingbracketfor7/8"
(2.2cm)shaft
• Bracketcover(2)
• Shoulderstrap
• Uppershoulderstrapclamp
• Lowershoulderstrapclamp(with
spacertabs)
• Handlebarbracketscrews(4)
• Shoulderstrapclampscrews(2)
• AttachmentHanger
• HexWrench
Examinepartsfordamage.Donotuse
damagedparts.
NOTE:Ifyouneedassistanceorfind
thatpartsaremissingordamaged,con-
tactyourSearsServiceCentre.
ASSEMBLY
WARNING:Ifreceivedassembled,
repeatallstepstoensureyourunitis
properlyassembledandallfasteners
aresecure.
• Ahexwrench(provided)isrequired
forassembly.
INSTALLINGBRUSHCUTTER AT-
TACHMENT
CAUTION: When removing or instal-
ling attachments, place the unit on a
flat surface for stability.
1. Loosen the coupler by turning the
knob counterclockwise=
Coupler
_OOSEN
TIGHTEN Knob
2. Remove the shaft cap from the
brushcutter attachment (if present).
3. Position locking/release button of
attachment into guide recess of
coupler.
4. Push the attachment into the cou-
pler until the locking/release button
snaps into the primary hole.
5. Before using the unit, tighten the
knob securely by turning clock-
wise.
Coupler Pnmary Hole
"\ / Guide Recess
!er oe ino
SP_ff RBe_ttaseAttL°_erent
£k
,ram,WARNING: Make sure the lock-
ing/release button is locked in the pri-
mary hole and the knob is securely
tightened before operating the unit.
HANDLEBAR ASSEMBLY
_lJ DANGER: RISK OF CUT. To avoid
serious injury, the barrier portion of the
handlebar must be installed as shown
on the upper shaft of the powerbead to
provide a barrier between operator and
the spinning blade. Attach handlebar
mounting bracket above arrow on
safety warning decal on the upper
shaft (powerhead end of unit).
Ensure handlebar is positioned on
mounting bracket at the end of the ar-
row on the handlebar decal.
NOTE: Two mounting brackets are in-
cluded with this attachment. Both brack-
ets are provided to adapt this attach-
ment for use with powerheads that have
either a 1" (2.5 cm) diameter or a 7/8"
(2.2 cm) diameter upper shaft. The cor-
rect bracket must be used to ensure that
the handlebar is mounted securely to
the upper shaft before use.
Handlebar _ _ Screw
ou2tito
J
Place the mounting bracket over
the upper shaft above the arrow on
the safety label. Be sure to use
the correct mounting bracket for
either the 1" (2.5 cm) or 7/8" (2.2
cm) diameter upper shaft.