Craftsman C944.511590 Lawn Mower Accessory User Manual


 
6, Retightenhandlebarbyturning
clampknobclockwiseuntilhandle-
barissecureandstationaryin
clamp(clampknobcannotbe
overtightened),
SHOULDERSTRAPASSEMBLY
i_ WARNING: Proper sbeulder strap
and handlebar ad ustments are required
before use, The shou der strap camp
must be installed as shown above the
handlebar on the upper tube (power-
head end of unit),
NOTE: The lower shoulder strap
clamp has two spacer tabs attached.
These tabs are provided to adapt this
attachment for use with powerheads
that have a 1" diameter upper tube
(the shoulder strap clamp will not tight-
en down securely on the 1" diameter
upper tube without using these spacer
tabs), The tabs must be broken off
completely before use and placed over
the screw holes on the lower shoulder
strap clamp. These tabs are not need-
ed for powerheads with a 7/8" upper
tube,
LOWER SHOULDER STRAP
CLAMP
Spacer Tabs_ub"l_l_lt_l_,_
.r_- SpacerTabs
positioned for use
on 1" diameter
upper tube
1,
2,
Place the upper shoulder strap
clamp over the upper tube above
the handlebar.
Position the lower shoulder strap
clamp under the upper tube and
align the upper and lower clamp
screw holes (use spacer tabs be-
tween upper and lower clamps if
necessary to secure clamp, i.e. for
1" diameter upper tube),
Upper Shoulder
Clamp
POWERHEAD
END
ATTACHMENT
LowerShoulden END
Strap Clamp
Scows
3, Insert two screws into the screw
holes.
4, Secure shoulder strap clamp by
tightening screws with the hex
wrench,
5, Try on shoulder strap and adjust for
fit and balance before starting the
engine or beginning a cutting opera-
tion,
6, Insert your right arm and head
through the shoulder strap and al-
low it to rest on your left shoulder,
Make sure the danger sign is on
your back and the hook is to the
right side of your waist.
NOTE: A one-half twist is built in the
shoulder strap to allow the strap to rest
flat on the shoulder,
7, Adjust the strap, allowing the hook
to be about 6 inches below the
waist.
8, Fasten the strap hook to the upper
clamp and lift the tool to the oper-
ating position,
Shoulder Strap
Shoulder
Stra
Clamp