Filter
Top Products
KNOW YOUR BRUSHCUTTER ATTACHMENT
READ THIS OPERATOR'S MANUALAND SAFETY RULES BEFORE OPERATING YOUR
BRUSHCUTTER ATTACHMENT. Compare the illustrations with your unit to familiar-
ize yourself with the location of various controls and adjustments, Save this
manual for future reference,
ocking Lever
e
Hanger _b, Gearbox _
Blade Shield "__ Blade
BLADE
The BLADE is designed for cutting grass,
weeds, and brush upto 1/2 inch in
diameter,
LOCKING LEVER
The LOCKINGLEVER is used to prevent
the blade shaft from turning during
blade replacement,
OPERATING THE COUPLER
Your powerhead is equipped with a
coupler which enables optional attach-
ments to be installed. The optional at-
tachments are:
Edger ............... C944,511570
Cultivator ............ C944.511580
Blower .............. C944,511600
WARNING: Always disconnect
powerhead spark plug before remov-
ing or installing attachments,
REMOVING ATTACHMENT
CAUTION: When removing or instal-
ling attachments, place the powerhead
and attachment on a flat surface for
stability,
1, Loosen the coupler by turning the
knob counterclockwise.
UpperTube
Coupler
Lower
Attachment
TIGHTEN Knob
2,
Press and hold the locking/release
button,
Locking/Release
Button
/
Lower Attachment
UpperTube
3, While securely holding the upper
tube, pull the attachment straight
out of the coupler,
INSTALLING ATTACHMENT
1, Remove the tube cap from the at-
tachment (if present)and discard.
2, Position locking/release button of
attachment into guide recess of
upper tube coupler.
Coupler Primary Hole
uide Recess
Upper Locking/ Attachment
Tube Release
Button
3, Push the attachment into the cou-
pler until the locking/release button
snaps into the primary hole,