Filter
Top Products
CARTONCONTENTS
Checkcartoncontentsagainstthefol*
lowinglist.
Model C944.511590
• Brushcutter Attachment
• Handlebar (with Clamp and Knob)
• Handlebar Clamp Base (with Spacer
Tabs)
• Shoulder Strap
• Upper Shoulder Strap Clamp
• Lower Shoulder Strap Clamp (with
Spacer Tabs)
• Clamp Screws (6)
• Attachment Hanger
• Hex Wrench
Examine parts for damage. Do not use
damaged parts.
NOTE: If you need assistance or find
that parts are missing or damaged, call
1-800-235-5878.
ASSEMBLY
_WARNING: If received assembled,
repeat all steps to ensure your unit is
properly assembled and all fasteners
are secure,
* A hex wrench (provided) is required
for assembly.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT. To
avoid serious injury, the barrier portion
of the handlebar must be installed as
shown on the upper tube of the power-
head to provide a barrier between op-
erator and the spinning blade. Attach
tube clamp above arrow on safety
warning decal on the upper tube (pow-
erhead end of unit). Ensure handlebar
is positioned on handlebar clamp be-
tween the arrows on the handlebar de-
cal.
NOTE: The tube clamp base has four
spacer tabs attached. These tabs are
provided to adapt this attachment for
use with powerheads that have a 1"
diameter upper tube (the tube clamp
will not tighten down securely on the 1"
diameter upper tube without using
these spacer tabs). The tabs must be
broken off completely before use and
placed over the screw holes on the
clamp base. These tabs are not need-
ed for powerheads with a 7/8" upper
tube.
HANDLEBAR CLAMP BASE
Spacer T_.._ ___1,4__
Spacer Tabs _
positioned for use--_ _
on 1" diameter _._,_,,,_
upper tube
1,
2.
Place the tube clamp over the up-
per tube above the arrow on the
safety decal.
Position the clamp base under the
upper tube and align the tube
clamp and clamp base screw
holes (use spacer tabs between
tube clamp and clamp base if nec-
essary to secure clamp, i.e. for 1"
diameter upper tube).
Handlebar
POWERHEAD
END
between arrows on
handlebar decal
Knob
Clamp Screws
Arrow on
Safety Decal
ATTACHMENT
END
3. Insert four screws into the screw
holes.
4. Secure tube clamp by tightening
screws with the hex wrench.
5. Position the handlebar as shown,
ensuring the handlebar is posi-
tioned on the handlebar clamp be-
tween the two arrows on the han-
dlebar decal.