Filter
Top Products
Tools Required for Assembly
Adjustable wrench
t/2" Socket
_ernove Pressure Washer from Carton
, Open carton from the top.. Locate and remove from
oat'ton, the parts box, which includes gun, handle,
wand,oil, knobs and bo]ts. Next remove the parts
bag and the handle,,
• Cut carton along dotted lines..
Remove all carton inserts.
- Roll unit through opening in carton.
Note; The pressure and chemical hose are located at
the bottom of the box.
Preparing the Pressure Washer for First Use
Note: Included wffh your pressure washer is a video
tape on how to prepare your unit for operation, it is
recommended you view this tape before performing
the next steps.
1. insert handle onto frame,
° Insert knobs into the threaded slot infront of the
frame handle and tighten by turning in a clockwise
direction.
o Slide bolts into the slot in the side of the frame
handle and tighten the nut by turning in a clockwise
direction.
2_
Remove wood plank from the frame of the unit,,
An adjustable wrench ts required, Discard bolt
and board.
3. Mount the rubber isolator to the frame,,
4.
* To mount isolator place threaded end of bolt
through the washer,.
° Next with washer on bolt place threaded end
of bolt through larger hole inbottom of the
rubber isolator,,Place _.hreaded portion of
isolator through the frqnt hole location where
the wood plank was mounted on the pressure
washer.
, Next plaoe lockwasher over threaded portion
of bolt that has been placed through the
mounting hole inthe pressure washer and use
nut to tighten isolator to the frame°
o Tighten nut with an adjustable wrench..
n t_L11"
pa_sul_l L0._/ .
c_-BoL'r
Connect wand with nozzle assembly to gun..To
tighten, turn knob in clockwise direction. Hand
tlghten_