Filter
Top Products
'Cleaning Pre-Ciean and Air Cleaner Catridge
To cleal_ pro-cleaner and air cleaner cartridge wash in
_[_quiddetergent and water. Allow to dry thoroughly
._eforel using. Do not oil pre-cleanero Replace if very
dirty or damaged.
To service air cleaner follow these steps:
1. Unscrew cover screws, Remove cover, foam pro -
cleaner, and air cleaner cartridge assembly,,
2. Remove cartiridge from cover,then retainer
(if equipped) and pre-cleaner_
3, To clean pre-cteaner and air cleaner cartridge, wash
inliquid detergent and water. Allow to dry thoroughly
before using Do not oil l;he prec!eaner or cartridge,
Replace if very dirty or damaged..
NOTE_ Do not use petroleum solvents, e.g., kerosene,
which wilt cause the cartridge to deteriorate., Do not
use pressurized airto clean cartridge. Pressurized air
can damage the cartiridge.
4. Reassemble pro-cleaner or retainer (if equipped.)
Place in cover with pre-cleaner mesh side toward
cartridge. Place cartridge in retainer in cover°
5, Push cover and air cleaner assembly squarely onto
base (tabs must be in slots, tf equipped) and hold
firmly° Tighten cover screws securely.
Check Engine-- Guard/Muffler
Do not clean engine with aforceful spray of water
because water could contaminate fuel system° With
a brush or cfoth clean finger guard after every use tO
prevent engine damage caused by overheating°
RNGEP,
GUARD
Before running engine, clean muffler area to remove el!
combustible debris.
CLEAN
Clean and Replace Spark Plug
Change the spark plug every 100 hours of operation or
once each year, whichever comes first. This will help
your engine to start easier and run better,
.030" (o.7_MM)
RESISTOR
14