Filter
Top Products
TOOLS REQUIRED FOR ASSEMBLY
(2) 7/16" Wrenches
(2) 9/16" Wrenches
(1) 3/4" Wrench
STEP 2: (SEE FIGURE 2)
* insert 1/4 x 1-1/4" hex bolt through one of the springs.
* Assemble 1/4 x 1-1/4" hex bolt onto the bumper using
two 1/4-20 hex nuts (SIMS) with end of bolt extending
slightly through outside nut.
* Repeat for spring on other side.
CAUTION! Muffler is hot! Allow engine to
cool down before proceeding with bumper
installation.
STEP 1: (SEE FIGURE 1)
• Slide the ends of the latch into the slots located on
the bottom of the bumper.
Push the front of the latch down past plastic shroud
of bumper. Latch will be under the shroud and
should appear as shown in figure 3 when assembled
correctly'.
Attach one spring onto the rod on each side of the
latch.
LATCH
_SPRING
FIGURE 1
4
1/4" HEX
NUT (SIMS)
114 X 1-114"
HEX BOLT
SPRING
FIGURE 2
STEP 3: (SEE FIGURE 3)
Assemble a 3/8 x 1" hex bolt, 3/8" washer, frame
brace and 3/8" lock nut to the rear hole of the bumper.
318 X 1"
HEX BOLT
318" WASHER /
\ /
318" LOCK NUT FRAME
BRACE
FIGURE 3
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE