Filter
Top Products
TROUBLESHOOTING CHART
CAUSE_ROBLEM
)oesnotsta_
_oor performance
_oor cut - uneven
Excessive
/ibration
o Fuse has been
removed from mower
o Charger has net been
unplugged from mower
charge port
o Battery may need to be
recharged
o Blade does not rotate freely
or mower deck is clogged
• Grass too high or thick
(Overload light is on 25%
of the time)
• Low battery voltage (Low
power light stays on while
mowing)
o Worn, bent or loose blade.
• Wheel heights uneven°
o Buildup of grass, and trash
leaves, under mower.
o Worn, bent or loose blade.
o Bent motor motorshafL
CORRECTION
= install fuse
o Remove charger plug from
mower charge port
o Charge battery
o Remove fuse, turn mower
on itssideandcheckblade.
Make sure it is free to
rotate.
Also check for clogging.
• Raise mower cutting height
to cut 1/3 of grass length.
• Walk at a slower pace so
overload light stays off.
• Reduce cutting width if
needed.
o Remove fuse, check
deck for clogging, check
blade for sharpness.
• Reduce cutting load
o Walk at slower pace
o Reduce cutting width
o Raise cutting height
o Recharge batteries
° Remove fuse.
° Replace blade. Tighten
blade boll
• Set all wheels at same
height.
o Remove fuse and cleanun-
derside of mower housing.
o Remove fuse.
o Replace blade. Tighten
blade bolt.
o Contact an authorized
service center.
15