Craftsman 917.379480 Lawn Mower User Manual


 
The operation of any lawn
mower can result in foreign
objects thrown into the eyes,
which can result in severe eye damage.
Always wear safety glasses or eye
shields while operating your lawn mower
or performing any adjustments or repairs.
We recommend a wide vision safety
mask over spectacles or standard safety
glasses.
ENGINE SPEED
The engine speed is controlled by a
throttle control located on the side of the
upper handle. Choke position is for
starting a cold engine and fast position
is for normal cutting, trimming, and better
grass bagging. Slow position is for light
cutting, trimming and fuel economy.
FAST _ _ SLOW
CHOKE '" "'" ' ""
•.-,; ,,,; .
#11 L II
ENGINE ZONE CONTROL
_CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
Your _awn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
TO ADJUST CUTTING HEIGHT
Raise wheels for low cut and lower
wheels for high cut.
Adjust cutting height to suit your
requirements. Medium position is best
for most lawns.
To change cutting height, squeeze
adjuster lever toward wheel. Move
wheel up or down to suit your require-
ments. Be sure all wheels are in the
same setting.
NOTE: Adjuster is properly positioned
when plate tab inserts into hole in lever.
Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the
plate tabs.
Lower Wheels for High Cut PlateTab
Lever
Raise Wheels for Low Cut
TO ATTACH GRASS CATCHER
Lift the rear door of the lawn mower
and place the grass catcher frame
hooks onto the door pivot pins.
The grass catcher is secured to the
lawn mower housing when the rear
door is lowered onto the grass catcher
frame.
_I,CAUTION: Do not run your lawn
mower without clipping deflector or
approved grass catcher in place. Never
attempt to operate the lawn mower with
the rear door removed or propped open.
Pivot _ins
Rear door
Grass
catcher
handle
/
Catcher
frame hook
TO EMPTY GRASS CATCHER
Lift up on grass catcher using the frame
handle.
Remove grass catcher with clippings
from under lawn mower handle,
Empty clippings from bag using both
frame handle and bag handle.
NOTE: Do not drag the bag when
emptying; it will cause unnecessary wear
ga¢
handle
_rass
catcher
*frame
handle
7