Filter
Top Products
• To check blade balance, drive a nail
into a beam or wall. Leave about one
inch of the straight nail exposed. Place
center hole of blade over the head of
the nail. If blade is balanced, it should
remain in a horizontal position. If either
end of the blade moves downward,
sharpen the heavy end until the blade
is balanced.
Lockwasher Spacer
Blade Sic
Blade washer
bolt Trailing/edge adapter
GRASS CATCHER
• The grass catcher may be hosed with
water, but must be dry when used.
• "Check your grass catcher often for
damage or deterioration. Through
normal use it will wear. If catcher
needs replacing, replace only with a
manufacturer approved replacement
catcher. Give the lawn mower model
number when ordering.
DRIVE WHEELS
Check front drive wheels each time
before you mow to be sure they move
freely.
The wheels not turning freely means
trash, grass cuttings, etc. are in the drive
wheel area and must be cleaned to free
drive wheels.
If necessary to clean the drive wheels,
check both front wheels.
,, Remove hubcaps, hairpin cotters and
washers.
• Remove wheels from wheel adjusters.
• Remove any trash or grass cuttings
from inside the dust cover, pinion and/
or drive wheel gear teeth.
• Put wheels back in place.
• If after cleaning, the drive wheels do
not turn freely, contact your nearest
.authorized service center.
GEAR CASE
• To keep your drive system working
properly, the gear case and area
around the drive should be kept clean
and free of trash build-up. Clean under
the drive cover twice a season.
• The gear case is filled with lubricant to
the proper level at the factory. The only
time the lubricant needs attention is if
service has been performed on the
gear case.
• If lubricant is required, use only Texaco
Starplex Premium 1 Grease, Part No.
750369. Do not substitute.
12
ENGINE
LUBRICATION
Use only high quality detergent oil rated with
API service classif_tion SI-, SG or SH.
Select the oil's SAE v'_,osily grade according
to your expected operating temperature.
SAE VISCOSITY GRADES
O.
._ .10. O* I0. 20" 3_,
TEMPERATURE RANGE ANTICtPAT_D BEFORE NEXT OIL CHANGE
NOTE: Although multi-viscosity oils (5W30,
10W30 etc.) improve startingin cold weather,
these multi-viscosityoils will result in
increased oil consumption when used above
32°F. Check your engine oil level more
frequen T to avoid possible engine damage
from running low on oil.
Change the oil after every 25 hoursof
operation or at least once a year if the lawn
mower is not used for 25 hours inone year.
Check the crankcase oil level before starting
the engine and after each five (5) hours of
continuous use. Tighten oil plugsecurely
each time you check the oil level.
TO CHANGE ENGINE OIL
NOTE: Before tipping lawn mower to
drain oil, drain fuel tank by running
engine until fuel tank is empty.
• Disconnect spark plug wire from spark
plug and place wire where it cannot
come in contact with spark plug.
• Remove engine oil cap; lay aside on a
clean surface.
• Tip lawn mower on its side as shown
and drain oil into a suitable container.
Rock lawn mower back and forth to
remove any oil trapped inside of
engine.
• Wipe off any spilled oil on lawn mower
and on side of engine.
• Fill engine with oil. Fill to the upper
limit mark on the dipstick. DO NOT
OVER FILL.