Filter
Top Products
Your new tiller has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tiller
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier. Standard wrench sizes are listed.
(1) Utility knife
(1) Wire cutter
(t) Tire pressure gauge
(1) Screwdriver
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION
When right or left hand is mentioned in
this manual, it means whenyou are in
the operating position (standing behind
tiller handles).
FRONT
LEFT
RIGHT
OPERATOR'S
POSITION
CONTENTSOF HARDWARE PACK
/IIIIIII/Y
(2) Handle Locks
(1) Carriage Bolt ,
3/8-16 UNC x I Gr. 5
121Ha,_,nc,,pst L ) )
_J"3/32x 1 x 11 Ga. '
°1 O
Extra Shear Pins & Clips
@
(1) Center Locknut
3/8-16 UNC
(1) Cable Clip
(1) Pivot Bolt
3/8-16 UNC Grade 5
(1) Handle Lock Lever
I
5