Filter
Top Products
TURNING
• Release the drive control bar.
• Move throttle control to =SLOW" posi-
tion.
• Place shift lever indicator in "F _ (forward)
position. Tines will not turn.
: Lift handle to raise tines out of ground.
Swing the handle in the opposite direc-
tion you wish to turn, bein'g careful to
keep feet and legs away from tines.
• Whenyou have completed your turn-
around, release the drive control bar and
lower handle. Place shift lever in till
position and move throttle control to de-
sired speed. To begin tilling, hold drive
control bar against the handle.
CULTIVATING
• Use the forward rotating tins drive.when
cultivating, tilling soft ground or tilling
pre-tilled soil.
• Release depth and drag stake pins.
Lower drag stake. Pull the depth §take
up for increased tilling depth. Place
proper pin in hole of depth stake or drag
stake to lock in position.
• Place shift lever indicator in forward
rotating till position.
• Hold the drive control bar against the
handle to start tilling movement. Tines
and wheels will both turn.
• Move throttle control to "FAST" position
for deep tilling. To cultivate, throttle con-
trol can be set at any desired speed,
depending on how fast or slow you wish
to cultivate.
• Always lower the drag stake when using
the forward rotating tins drive.
OUTER SIDE SHIELDS
The back edges of the outer side shields
are slotted so that the shields can be
raised for deep tilling and lowered for shal-
low tilling to protect small plants from
being buried. Loosen nut =A" in slot and
nut =l_". Move shield to desired position
(both sides). Retighten nuts.
TO TRANSPORT
_CAUTION: Before lifting or transport-
ing, allow tiller engine and muffler to cool.
Disconnect spark plug wire. Drain gaso-
line from fuel tank.
AROUND THE YARD
Release the depth s_takepin. Move the
dr.pth stake down to the top hole for
transporting the tiller. Place depth stake
pin in hole of depth stake to lock in posi-
tion. This prevents tines from scuffing
the ground.
• Place '.;hi_ lever indicator in "F" (forward)
position for transporting.
• Hold the drive control bar against the
handle to start tiller movement. Tines
will not turn.
• Move throttle control to desired speed.
AROUND TOWN
• Disconnect spark plug wire.
• Drain fuel tank.
• Transport in upright position to prevent
oil leakage.
BEFORE STARTING ENGINE
IMPORTANT: Be very careful not to allow
dirt to enter the engine when checking or
adding oil or fuel. Use clean oil and fuel
and store in approved, clean, covered con-
tainers, use clean fill funnels.
CHECK ENGINE OIL LEVEL
• The engine in your unit has been
shipped, from the factory, already filled
with SAE 30 summer weight oil.
With engine level, clean area around oil
filler plug and remove plug.
Engine oil should be to point of overlow-
ing when engine is level For approxi-
mate capacity see "PRODUCT SPECI-
FICATIONS" on page 4 of this manual.
All oil must meet A.P.I. Service
Classification SF, SG or SH.
Reinstall engine oil cap and tighten
For cold weather operation you should
change oil for easier starting (See oil
viscosity chart in the Customer
Responsibilities section of this manual).
To change engine oil, see the Customer
Responsibilities section in this manual.
ADD GASOLINE
• Fill fuel tank. Use fresh, clean, regular
unleaded gasoline. (Use of leaded
gasoline will increase carbon and lead
oxide deposits and reduce valve life.
IMPORTANT: When operating in tempera-
tures below 40°F (4°C), use fresh, clean,
winter grade gasoline to help insure good
cold weather starting.
10