Filter
Top Products
TRANSAXLE GEAR SHIFT LEVER NEU-
TRAL ADJUSTMENT
The transaxle should be in neutral when the
gear shift lever is in neutral (N) (lock gate)
position, The adjustment is preset at the
factory; however, if adjustment is needed,
proceed as follows:
1, Make sure transaxle is in neutral (N),
NOTE: When the tractor rear wheels move
freely, the transaxle is in neutral
2, Loosen adjustment bolt in front of the
right rear wheel.
3, Position the gear shift lever in the neutral
(N) position,
4. Tighten adjustment bolt securely.
NOTE: If additional clearance is needed to
get to adjustment bolt, move mower deck
height to the lowest position.
Gearshift Adjustment Bolt
Lever
,,.,_ :ral
/ _,__ '! Lock Gate
TO REMOVE WHEEL FOR REPAIRS
i. Block up axle securely_
2. Remove axle cover, retaining ring and
washers to allow wheel removal (rear
wheels have a square key - Do not Iose)_
3. Repair tire and reassemble.
NOTE: On rear wheels only: align grooves in
rear wheel hub and axle. Insert square key.
4. Reptacewashers and snap retaining ring
securely in axle groove,
5. Replace axle cover.
NOTE: To seal tire punctures and prevent
flat tires due to slow leaks, purchase and
use tire sealant from Sears. Tire sealant also
prevents tire dry rot and corrosion,
Retaining
Axle
Cover
Washers
Square
Key ly.
(Rear Wheel Only) -='_-
28
TO CHECK BRAKE
tf tractor requires more than five (5) feet to
stop at highest speed in highest gear on a
level, dry concrete or paved surface, then
brake must be serviced.
You may also check brake by:
!. Parktractoron alevel, dryconcreteor paved
surface, depress clutch/brake pedal all
the way down and engage parking brake.
2. Place gear shift lever in neutral position.
The rear wheels must lock and skid when
you try to manually push the tractor forward.
If the rear wheels rotate, then the brake
needs to be serviced. Contact a Sears or
other qualified service center.
TO START ENGINE WITH A WEAK BAT-
TERY
_IbWARNING: Lead-acid batteries gener-
ate explosive gases_ Keep sparks, flame
and smoking materials away from batteries.
Always wear eye protection when around
batteries,
Ifyour battery is too weak to start the engine, it
should be recharged. (See "BATTERY" in the
MAINTENANCE section of this manual).
if "jumper cables" are used for emergency
starting, follow this procedure:
IMPORTANT: Your tractor is equipped with
a 12 volt system, The other vehicle must also
be a i 2 volt system_ Do not use your tractor
battery to start other vehicles°
TO ATTACH JUMPER CABLES
I. Connect one end ofthe RED cable to the
POSITIVE (+) terminal of each battery(A-
B), taking care notto short against tractor
chassis.
2. Connect one end of the BLACK cable
to the NEGATIVE (_) terminal (C) of fully
charged battery.
3. Connect the other end of the BLACK
cable (D) to good chassis ground, away
from fuel tank and battery.
TO REMOVE CABLES, REVERSE
ORDER
I. BLACK cable first from chassis and then
from the fully charged battery.
2. RED cable last from both batteries.
Weak or Dead Fully Charged
Battery Battery