Filter
Top Products
TROUBLESHOOTING CHART
CAUSE CORRECTIONPROBLEM
Loss of power
continued)
Excessive
vibration
Engine continues
to run when
operator leaves
seat with
attachment
;lutch engaged
Poorcut-uneven
Mower blades will
not rotate
3. Build-up of grass, leaves
and trash under mower.
4. Dirty air filter,
5. Low oil level/dirty oil.
6. Faulty spark plug.
7. Dirtyfuel filter.
8. Stale or dirtyfuel.
9. Water in fuel,
10.Spark plug wire loose.
11. Dirty engine air screen/fins.
12. Dirty/clogged mufflen
13,Loose or damaged widng.
14,Carburetor out of
adjustment.
15.Engine valves out of
adjustment.
1. Worn, bent or loose blade.
2. Bent blade mandrel.
3. Loose/damaged part(s).
1. Faulty operator-safety
presence control system.
1. Worn, bent or loose blade.
2. Mower deck not level.
3. Buildupof grass, leaves,
and trash under mower,
4. Bent blade mandrel.
5. Clogged mower deck vent
from build-up of grass,
leaves, and trash around
mandrels.
1. Obstruction in clutch
mechanism.
2. Worn/damaged mower
drive belt.
3. Frozen idler pulley.
4. Frozen blade mandrel.
3. Clean underside of mower
housing.
4. Clean/replace air filter.
5. Check oil level/change oil.
6. Clean and regap or change
spark plug.
7. Replace fuel filter.
8. Drain fuel tank and refill
with fresh gasoline.
9. Drain fuel tank and
carburetor, refilltank with
fresh gasoline and replace
fuel filter.
10.Connect and tighten spark
plug wire.
11.Clean engine air screen/
fins.
12.Clean/raplace muffler.
13.Check all widng.
14.See "ToAdjust Carburetor"
in Service Adjustments
section.
15. Contact a Sears or other
qualified service center.
1. Replace blade.
Tighten blade bolt.
2. Replace blade mandrel.
3. Tighten loose part(s).
Replace damaged parts.
1. Check wiring, switches and
connections. If not corrected
contact a Sears or other
qualified service center.
1. Replace blade. Tighten
blade bolt.
2. Level mower deck.
3. Clean underside of mower
housing.
4. Replace blade mandrel.
5. Clean around mandrels to
open vent holes.
1. Remove obstruction.
2. Replace mower drive belt.
3. Replace idler pulley.
4. Replace blade mandrel.
31