Filter
Top Products
rROUBLESHOOTING CHART
CAUSE CORRECTION
PROBLEM
Poor grass
discharge
Headlight(s) not
working
(if so equipped)
Battery will not
charge
Loss of drive
Engine "backfires"
when turning
engine
"OFF"
1. Engine speed too slow.
2. Travel speed too fast.
3. Wet grass.
4. Mower deck not level.
5. Low/uneven tire sir
pressure.
6. Worn, bent or loose blade.
7. Buildup of grass, leaves and
trash under mower.
8. Mower drive belt worn.
9. Blades improperly installed.
10.Improper blades used.
1t.CIogged mower deck vent
holes from buildup of
grass, leaves, and trash
around mandrels.
1. Switch is =OFF".
2. Bulb(s) burned out.
3. Faulty light switch.
4. Loose or damaged wiring.
5. Blown fuse.
1. Bad battery cell(s).
2. Poor cable connections.
3. Faulty regulator
(if so equipped).
4, Faulty alternator.
1. Freewheel control in
"disengaged" position.
2. Motion drive belt worn,
damaged, or broken.
3. Air trapped in transmission
during shipment or
servicing.
1. Enginethrottlecontrolnst
setat "SLOW"
positionfor 30 seconds
stopping engine.
1. Place throttle control in
"FAST" position.
2. Shift to slower speed.
3. Allow grass to dry before
mowing.
4. Level mower deck.
5. Check tires for proper air
pressure.
6. Replace/sharpen blade.
Tighten blade bolt.
7. Clean underside of mower
housing,
8. Replace mower drive belt,
9. Reinstall blades sharp edge
down.
10. Replace with blades listed
in this manual,
11.Clean around mandrels to
open vent holes.
1. Turn switch "ON".
2. Replace bulb(s).
3. Check/replace light switch,
4. Check wiring and connec-
tions.
5. Replace fuse.
1. Replace battery.
2. Check/cleanall connec-
tions.
3. Replace regulator.
4. Replace alternator.
1. Placefreewheel controlin
=engaged" position.
2. Replace motiondrive belt.
3. Purge transmission.
1. Move throttle control ts
=SLOW" position and allow
to idle for 30 seconds befsra
stopping engine.
32