Filter
Top Products
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for replac-
ing motion and mower blade drive belts in
the Service and Adjustments sectoin of
this manual. Verify that the belts are rout-
ed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your trac-
tor, check to see that the brake is properly
adjusted. See "TO ADJUST BRAKE" in
the Service and Adjustments section of
this manual.
INSTALL MULCHER PLATE
• Install two latch hooks to mulcher plate
usingscrew, washer, lock washer, and
weld nut as shown.
NOTE: Preoassemble weld nut to latch
hook by inserting weld nut from the top
with hook pointing down.
• Tighten hardware securely.
• Raise and hold deflector shield in ulP
right position.
• Place front of mulcher plate over front of
mower deck opening and slide into
place, as shown.
• Hook front latch into hole on front of
mower deck.
• Hook rear latch into hole on back of
mower deck.
Weld Nut From Hook Points
The Top \ Down
Lock
Weld Washer
Screw
Latch Latch
Washer
Mulcher
Plate
Nut •
LookWasher
Washer
'_._ Screw
Deflector
Shield
.atch Hooks
_,CAUTION: Do not remove discharge
guard from mower. Raise and hold guard
when attaching mulcher plate and allow it
to rest on plate while in operation.
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in
a safe place. Your mower is now ready for
discharging or installationof optional
grass catcher accessory.
NOTE: It is not necessary to change
blades. The mulcher blades are designed
for discharging and bagging also.
CHECKLIST
PLEASE REVIEW THE FOLLOWING
CHECKLIST:
_' All assembly instructionshave been
completed,
_/ No remaining loose parts in carton.
v' Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
v' Seat isadjusted comfortably and
tightened securely.
All tires are properly inflated. (For
shipping purposes, the tires were
overinflated at the factory).
Be sure mower deck is properly leveled
side-to-side/front-to-rear for best
cutting results. ('13resmust be properly
inflated for leveling).
Check mower and drive belts. Be sure
they are routed properly around pulleys
andinside all belt keepers.
Check wiring. See that all connections
are stillsecure and wires are properly
clamped.
Before driving tractor,be sure free-
wheel contro/is in drive position.
WHILE LEARNING HOW TO USE YOUR
TRAGTOR, PAY EXTRAATTENTION TO
THE FOLLOWING IMPORTANT ITEMS:
,/ Engine oil is at proper level.
/ Fuel tank is filled with fresh, clean,
regular unleaded gasoline.
4' Become familiar with all controls - their
location and function. Operate them
before you start the engine.
/ Be sure brake system is in safe operat-
ing condition.
,/ Itis important to purge the transmis-
sion before operating your tractor for
the first time. Follow proper starting
and transmission purging instructions
(See "TO START ENGINE" and
"PURGE TRANSMISSION" in the Op-
eration section of this manual).
10