Filter
Top Products
ASSEMBLE GAUGE WHEELS TO
MOWER DECK
The gauge wheels are designed to keep
the mower deck in proper position when
operating mower. Be sure they are proper-
ly adjusted to ensure optimum mower per-
formance.
- Assemble gauge wheels with tractor on
a fiat level surface.
o Adjust mower to desired cutting height
(See '_FO ADJUST MOWER CUTTING
HEIGHT" in the Operation section of this
manual).
• With mower in desired height of cut poo
sit!on, gauge wheels should be assem-
bled so they are slightly off the ground.
Install gauge wheel in appropriate hole
with shoulder bolt, 3/8 washer, and 3/8-
16 Iocknut and tighten securely.
o Repeat for opposite side installing
gauge wheel in same adjustment hole.
Gauge Wheel
Bracket
\
3/8-16 Lockr
3/8-16 Washer
ge Wheel
Bolt
_ CHECKLIST
Please review the fo!lowing checklist:
,I All assembly instructions have been
completed.
,/" No remaining loose parts in carton.
J" Battery is properly prepared and
charged. (Minimum 1 hour at 6 amps).
,/Seat is adjusted comfortably and tight-
ened securely.
,f All tires are properly inflated. (For ship-
ping purposes, the tires were overinfiat-
ed at the factory).
J" Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting
results. (Tires must be properly inflated
for leveling),
,I Check mower and drive belts. Be sure
they are routed properly around pulleys
and inside all belt keepers.
,/" Check wiring. See that all connections
are still secure and wires are properly
clamped.
While learning how to use your tractor, pay
extra attention to the following important
items:
,/Engine oil is at proper level.
#" Fuel tank is filled with fresh, clean, regu-
lar unleaded gasoline.
,/Become familiar with al_ controls - their
location and function. Operate them
before you start the engine.
,/" Be sure brake system is in safe operat-
ing condition.
t 1