Filter
Top Products
CHECK TIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shipping purposes.
Correct tire pressure is important for best
cutting performance.
• Reduce tire pressure to PSI shown in
"PRODUCT SPECIFICATIONS" on
page 5 of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be properly leveled. See "TO
LEVEL MOWER HOUSING" in the
Service and Adjustments section of this
manual.
CHECK FOR PROPER POSITION OF
ALL BELTS
See the figures that are shown for replac-
ing motion and mower blade drive belts in
the Service and Adjustments sectoin of
this manual. Verify that the belts are rout_
ed correctly_
CHECK BRAKE SYSTEM
After you learn how to operate your trac-
tor, check to see that the brake is properly
adjusted. See 'q'O ADJUST BRAKE" in
the Service and Adjustments section of
this manual
INSTALL MULCHER PLATE
° Install two latch hooks to mulcher plate
using screw, washer, lock washer, and
weld nut as shown.
NOTE: Pre-assemble weld nut to latch
hook by inserting weld nut from the top
with hook pointing down.
o Tighten hardware securely.
° Raise and hold deflector shield in up-
right position.
• Place front of mulcher plate over front of
mower deck opening and slide into
place, as shown.
° Hook front latch into hole on front of
mower deck.
o Hook rear latch into hole on back of
mower deck.
Weld Nut From
The Top
Lock
Weld Washer
Nut
Hook Points
Down
Latch
Washer
Mulcher
Plate
Deflector
Shield
Latch
Hook
Weld Nut
Lock Washer
Washer
Screw
Hooks
,_,CAUTION: Do not remove discharge
guard from mower. Raise and hold guard
when attaching mulcher plate and allow it
to rest on plate while in operation.
TO CONVERT TO BAGGING OR
DISCHARGING
Simply remove mulcher plate and store in
a safe place, Your mower is now ready for
discharging or installation of optional
grass catcher accessory.
NOTE' It is not necessary to change
blades. The mufcher blades are designed
for discharging and bagging also.
t0