Filter
Top Products
Clamp Clamp
FuelFilter
CLEANING
• Clean engine, battery, seat, finish, etc.
of all foreign matter.
• Keep finished surfaces and wheels free
of all gasoline, oil, etc.
• Protect painted surfaces with automo-
tive type wax.
We do not recommend using a garden
hose to clean your tractor unless the elec-
trical system, muffler,air filter and carbure-
tor are covered to keep water out. Water
in engine can result in a shortened engine
life.
_,CAUTION: Before performing any service or adjustments:
• Depress clutch/brake pedal fully and set parking brake.
• Place motion control lever in neutral (N) position.
• Place attachment clutch in =DISENGAGED" position.
• Tum ignition key "OFF" and remove key.
• Make sure the blades and all moving parts have completely stopped.
• Disconnect spark plug wire from spark plug and place wire where itcannot come
in contact with plug.
TO REMOVE MOWER
Mower will be easier to remove from the
right side oftractor.
• Place attachment clutch in "DISEN-
GAGED" position.
• Move attachment lift lever forward to
lower mower to its lowest position.
• Roll belt off engine pulley.
• Disconnect clutch red from clutch lever
by removing retainer spring.
• Disconnect anti-swaybar from chassis
bracket by removing retainer spring.
• Disconnect suspension arms from rear
deck brackets by removing retainer
springs.
Suspe_on
Arms
• Disconnect front links from deck by
removing retainer springs.
• Raise liftlever to raise suspension
arms. Slide mower out from under trac-
tor.
IMPORTANT: If an attachment other than
the mower deck isto be mounted on the
tractor, remove the front links.
TO INSTALL MOWER
• Raise attachment lift leverto its highest
position.
• Slide mower under tractor with dis-
charge guard to right side of tractor.
• Lower lift lever to its lowest position.
• Install mower in reverse order of
removal instructions.
Retainer
Engine Pulley
• Front
Link
Retainer
Spring
AntJ-Swaybar
;pdngs
(BothSides)
;pdngs
(Both Sides)
23