Craftsman 917.27066 Lawn Mower User Manual


 
ing hot months. For healthier and better
looking lawns, mow often and after
moderate growth.
For best cutting performance, grass
over 6 inches in height should be
mowed twice. Make the first cut rela-
tively high; the second to desired
height.
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt by
the operator to leave the seat with the
engine running and the attachment clutch
engaged will shut off the engine.
Select desired height of cut.
Start mower blades by engaging
attachment clutch control.
TO STOP MOWER BLADES - disen-
A_lLgageattachment clutch control.
CAUTION: Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the discharge
guard in place.
TO OPERATE ON HILLS
CAUTION: Do not drive up or down
hills with slopes greater than 15 ° and do
not drive across any slope. Use the slope
guide provided at the back of this manual•
Choose the slowest speed before
starting up or down hills.
Avoid stopping or changing speed on
hills.
If slowing is necessary, move throttle
control lever to slower position.
If stopping is absolutely necessary,
push clutch/brake pedal quickly to
brake position and engage parking
brake.
Move motion control lever to neutral (N)
position.
IMPORTANT: The motion control lever
does not return to neutral (N) position
when the clutch/brake pedal is de-
pressed.
Attachment Clutch Attachment Lift
Lever "Engaged_--_ Lever High Position
Position __.
+':_'+
*'Dlsengaged-_--_,v//'=,]l } ._,::"L"_Low Position
Position t. __ .._:-'_
,_"
DiS3hdrge
CHECK ENGINE OIL LEVEL
The engine in your tractor has been
shipped, from the factory, already filled
with summer weight oil.
Check engine oil with tractor on level
ground.
Remove oil fill cap/dipstick and wipe
clean, reinsert the dipstick and screw
cap tight, wait for a few seconds,
remove and read oil level. If necessary,
add oil until "FULL" mark on dipstick is
reached. Do not overfill.
To restart movement, slowly release
parking brake and clutch/brake pedal.
Slowly move motion control lever to
slowest setting.
Make all turns slowly.
TO TRANSPORT
When pushing or towing your tractor, be
sure to disengage transmission by
placing freewheel control in freewheeling
position. Free wheel control is located at
the rear drawbar of tractor.
Raise attachment lift to highest position
with attachment lift control.
Pull freewheel control out and down
into the slot and release so it is held in
the disengaged position.
Do not push or tow tractor at more than
two (2) MPH.
To reengage transmission, reverse
above procedure.
NOTE: To protect hood from damage
when transporting your tractor on a truck
or a trailer, be sure hood is closed and
secured to tractor. Use an appropriate
means of tying hood to tractor (rope, cord,
etc.).
TOWING CARTS AND OTHER
ATTACHMENTS
Tow only the attachments that are
recommended by and comply with
specifications of the manufacturer of your
tractor. Use common sense when towing.
Too heavy of a load, while on a slope, is
dangerous. _res can lose traction with the
ground and cause you to lose control of
your tractor.
BEFORE STARTING THE ENGINE
14