Filter
Top Products
AIR FILTER FOAM PRE-CLEANER (See Fig.
14)
Your engine will not run properly and may be damaged by
using a dirty air filter° Clean the foam pro-cleaner element
after every 25 hours of operation, more often if used in very
dusty, dirty conditions,
• Remove knob and cover,
, Remove cartridge nut and replace cartridge.
• Reassemble and tighten securely.
NOTE= Do not attempt to clean or oil the paper cartridge.
Replace paper cartridge once a year or after every 100
hours of operation, more often if used in very dusty, dirty
conditions_
• Wash foam pre-cleaner in liquid detergent and water.
• Wrap foam pre-cleaner in cloth and squeeze dry.
° Lightly coat foam pro-cleaner with clean engine oil.
Squeeze in towel to remove excess oil. Do not satu-
rate.
, Install foam pre-cleaner over paper cartridge°
• Reassemble cover and secure with knobs,
COVER
KNOB
FIG. 14
AIR SCREEN (See Fig. 15)
The englne air screen must be kept free of dirt and chaff to
prevent engine damage from overheating. Clean with a
wire brush or compressed air to remove dirt and stubborn
dried gum fibers.
ENGINE COOLING FINS (See Fig. 15)
Remove any dust, dirt or oil from engine cooling fins to
prevent engrne damage from overheating.
• Remove oil fill dipstick and cover opening to prevent
entry of dirt
• Remove screws from blower housing and lift housing
off engine.
• Remove the screws securing the starter housing and
lift housing off engine,
• Use compressed air or stiff bristle brush to thoroughly
clean engine cooling fins.
• To reassemble, reverse above procedure.
BLOWER HOUSING
SCREWS
SCREWS
AIR SCREEN
/
STARTER
HOUSING
OIL FILL
DIPSTICK
ENGINE COOLING FINS
SPARK
PLUG
FIG. 15
MUFFLER
inspect and replace corroded muffler and spark arrester (if
equipped) as it could create a fire hazard and/or damage,
SPARK PLUGS
Replace spark plugs at the beginning of each mowing
season or after every 100 hours of operation, whichever
comes first. Spark plug type and gap setting are shown in
PRODUCT SPECIFICATIONS on page 3 of this manual.
IN-LINE FUEL FILTER (See Fig. 16)
The fuel filter should be replaced once each season. If fuet
filter becomes clogged, obstructing fuel flow to carburetor,
reptacement is required.
• With engine coot, remove filter and plug fuel line
sections.
• Place new fuel filter in position in fuel line.
. Be sure there are no fuel line leaks and clamps are
properly positioned.
• immediately wipe up any spilled gasoline.
CLAMP
FIGo t6
CLEANING
* Clean engine, battery, seat, finish, etc. of all foreign
matter.
• Keep finished surfaces and wheels free of all gasoline,
oil, etc.
• Protect painted surfaces with automotive type wax°
We do not recommend using a garden hose to clean your
tractor unless the electrical system, muffler, air fi{ter and
carburetor are covered to keep water out. Water in engine
can result in a shortened engine fife,.
17