Filter
Top Products
$ERVUCE
i ii iii ill ii illll ,Ulllllllllll,l,,,i
TO ADJUST BRAKE (See Fig. 24)
Your unit is equipped with an adjustable brake system
which is mounted on the right side of the transaxle
if unit requires more than six (6) feet stopping distance at
high speed in highest gear, then brake must be adjusted.
• Depress clutch/brake pedal and engage parking brake,
• Measure distance between brake operating arm and
nut "A" on brake red,
AND ADJUSTMENTS
:T
TO REPLACE MOTION DRIVE BELT (See
Fig. 25)
tf distance is other than 1-1/2", disengage parking
brake, loosen jam nut and turn nut "A" until distance
becomes 1-1/2", Retighten )am nut against nut "A",
Engage parking brake and recheck distance,
Road test unit for proper stopping distance as stated
above, Readjust if necessary. If stopping distance is
still greater than six (6) feet in highest gear, further
maintenance is necessary Contact your nearest
Sears Service Center,
W_H PARKING BRAKE "ENGAGED"
\
NUT"A"
NUT "A"
/ / JAM NUT
_opE_j - ARMRATING
FIG, 24
The tractor drive belt may be replaced without tools,
Park the tractor on level area, Engage parking brake,
For assistance, there is a belt installation guide decal on
bottom side of left footrest,
• Remove mower (See "TO REMOVE MOWER" in this
section of this manual)_
• Roll belt over top of transaxle pulley°
• Roll beft over engine pulley and off idler,
• Release parking brake, Pull belt as far as possible
over top of clutch pulfey.
• Reset parking brake Pull belt over top of clutch
pulley,
• Pull belt out up through gearshift lever gate opening
to remove from tractor,
• install new belt by reversing above procedure
IMPORTANT: REPLACE ONLY WITH BELT LISTED IN
THIS MANUAL
NGINE
CLUTC H PULLEY
IDLER BELT
VIEWED FROM BOTTOM OF TRACTOR
FIG. 25
21