Filter
Top Products
CONTAINER MOUNTING (See Fig. 3)
1. Install one container to left side first. Install another
container to center position and one in right position.
NOTE: Left edge of right container should always overlap
right edge of left container at center supports.
2. Close cover and lock latch handles over center support
tubes.
COVER LATCH
HANDLES
CENTER
SUPPORT
TUBES
CONTAINER
HANDLE
FIG.3
LOWER CHUTE (See Fig, 4)
1. Raise and hold deflector shield in upright position.
2. Place slot in lower chute over mountingtab on mower and
position lower chute over mower opening as shown.
3. Hook rear latch into flange hole on back of mower.
4. Hook front latch into tab hole on front of mower.
• If your tractor is equipped with gauge wheels on the
deck, then it will be necessary to hook the rear latch
into the hole in the R.H. gauge wheel bracket.
DEFLECTOR SHIELD
HINGE BRACKET
MOUNTING TAB
CAUTION: Do not remove deflector
shield from mower, Raise and hold
shield when attaching lower chute
and allow it to rest on chute while in
operation.
DEFLECTOR
SHIELD
03058
REAR GAUGE
WHEEL
BRACKET
WiTH REAR
GAUGE WHEELS
REAR LATCH
WITHOUT
GAUGE WHEELS
FiG. 4
REAR LATCH
FRONT
LATCH
6