Filter
Top Products
HANG SUPPORT ASSEMBLY ON
REAR DRAWBAR (See Fig. 1)
1. Slide flanges of support assembly into drawbar slots
first, then, pivot backwards inserting pin into drawbar
pin hole.
2. Be sure support assembly is seated properly, then
secure with retainer spring,
SUPPORT
ASSEMBLY
DRAWBAR SLOTS
"A" shown)
DRAWBAR
PIN HOLE
FIG. 1
03128
RETAINER
SPRING
INSERT
FLANGES
FIRST INTO
DRAWBAR
SLOTS
MOUNTING COVER ASSEMBLY TO
SUPPORT ASSEMBLY (See Fig. 2)
NOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting cover assembly
to tractor.
1. Lift cover and align cover brackets with support
assembly tubes.
2. Slide cover assembly down onto the support tubes.
\
COVER
ASSEMBLY
SUPPORT
ASSEMBLY
03024
FIG. 2
5